Oak board

MS GREAT GROUP

Cod - 44420606 Chernivtsi, Ukraine. St. SIDI - TAL 7/4

COMMERCIAL PROPOSAL

Wood variety: oak (floorboard)

Quality:

I grade - four sides clean without defects - knots, sapwood, heartwood and other defects are not allowed. Single fresh knots

up to 5mm are allowed, located no closer than 10mm from the edges of the board.

II Grade - fresh knots up to 20mm are permissible, as well as hard black ones up to 8mm, located no closer than 15mm from

the edges of the board and sapwood up to 30% of the board width. Core and other defects are not allowed.

III grade - fresh, light knots up to 35mm are acceptable, as well as black firm ones up to 25mm, located no closer than

10mm from the edges of the board. Sapwood is permissible up to 50% of the board width on both sides, but not more than

30% of the total number of boards supplied. Core and other defects are not allowed.

IV Grade - permissible fresh, intergrown knots up to 60mm, black solid and also rotten tobacco - up to 30mm and a

maximum of up to 2 pieces per 1 board. All knots should be located no closer than 10mm from the edges of the board - the

edges are clean. One fresh (not black) branch with a diameter of up to 40mm, can go to the edge of the board. Healthy

sapwood is allowed without restrictions. A one - sided sporadic core is also permissible on one side of the board and always

with a sawn center. Ingrown bark is allowed on one side of the board up to a maximum of 200mm in length and 3mm in

width in an amount of 2 pieces.

1p grade - single fresh knots up to 10mm are permissible, located no closer than 10mm from the edges of the board, as well

as a solid, healthy subpair. Sapwood, heartwood and other defects are not allowed.

Rot, wormholes, cracks of all kinds, changes in natural color (mold, fungus, etc. ), curvature of annual fibers - oblique, frost

rings, mechanical damage (nails, slings, bullets, etc. ), wane in all higher these varieties are unacceptable. The section of the

assortment must be rectangular; it is also required to maintain the dimensions and correct geometric shapes.

 General Director

of the Company

MS GREAT GROUP Іvan Stefanchuk